Meiteng wall cloth construction secret collection

2022-07-22
  • Detail

Compared with wallpaper, the natural and environmental protection characteristics of wall cloth have more advantages, so it is also increasingly concerned by consumers. The popularity of wall coverings in the domestic home decoration market is not high, and many consumers do not know how to lay them after buying enough wall coverings. Today, the construction secret of Meiteng wall cloth was officially announced

the natural and environmental protection characteristics of wall cloth have more advantages than wallpapers, so they are also increasingly concerned by consumers. The popularity of wall coverings in the domestic home decoration market is not high, and many consumers do not know how to lay them after buying enough wall coverings. Today, the construction secret of Meiteng wall cloth was officially announced

posting of the wall cloth at the external corner

step 1: carefully stick the wall cloth with a scraper and step over the convex corner, but do not stick to the other wall

step 2: fold the convex wall corner by hand from top to bottom, and draw a vertical line from the ceiling to the floor, 12.5px away from the convex wall

step 3: cut the wall cloth along the above vertical line with a art knife, and guide it with a ruler

step 4: carefully pull apart the remaining wall cloth and put it on the workbench for later use

step 5: use the joint pressing wheel to level the outstretched part of the wall cloth, and then add glue on the wall cloth covered with glue

step 6: mount the wall cloth pasted with the cover, spell the pattern, scrape the wall cloth with a scraper, and press it with a pressing wheel

posting of the wall cloth at the inner corner

1) treatment of the inner corner of the house without settlement

step 1: measure from the center of the last wall cloth to the concave corner, add 62.5px, and cut a section of wall cloth according to this width

step 2: stick the above section of wall cloth, align it with and connect the last wall cloth, and flatten it on the concave corner

step 3: scrape up and down with a scraper to make the outstretched part stick to the wall, and wipe the glue on the scraper dry

step 4: measure the width of this section outward from the concave corner, add 5mm, and make a mark on the wall

step 5: put a level on the pencil mark, check whether it is really vertical, and apply glue on the wall cloth pasted on the cover

step 6: align the outside of the covered wall cloth with the vertical line, which shall prevail, and mount the remaining seamless wall cloth in the room

2) the treatment method of the internal corner of the house where settlement occurs

step 1 to step 3: the same as above

step 4: paste another wallpaper over the previous one, align the floral wallpaper, and turn to the other wall

step 5: flatten the back of the scraper at the inner corner

* note: first, slowly press the wall cloth close to the internal corner by hand, and then slowly flatten the internal corner on the back of the scraper. Do not use force to avoid hurting the wall cloth

step 6: scrape the crease repaired along the edge at a distance of 2mm from the internal corner, and cut it from top to bottom with a ruler and an art knife

step 7: remove the excess wall cloth and wipe the excess glue with a white towel or sponge

sticking method at the switch

the first method: first stick the wall cloth cover to the whole switch opening, then brush it flat with a wooden handle, and then draw a cross on the diagonal line with a art knife, but the force should be appropriate, do not scratch the switch, use a scraper to hold the edge of the switch, and use a art knife to cut off the excess wall cloth

second:

step 1: stick the wall cloth cover to the whole switch

step 2: at the four corners of the opener, cut four points towards the center with an art knife

step 3: cut a parallel line at LCM from the long edge of the switch, but the distance from the short edge on both sides of the switch is also 1cm

step 4: at the midpoint of the above drawn equal line, draw a vertical line with an art knife, 75px from the lower edge

step 5: draw a line between the two lower points and the vertical line with an art knife

step 6: hold the edge of the switch box with a scraper and cut off the excess wall cloth with a art knife

pasting method of doors and windows

if the door pocket is not made in general houses, there are two parts of the upper part of the window pocket that need to be pasted with wall cloth. The method is as follows:

step 1: paste the wallpaper to be pasted on the edge of the wall cloth closest to the left and right of the window, and paste the excess extended parts on the upper and lower parts of the window respectively

step 2: draw parallel lines along the upper and lower edges of the middle window with an art knife

step 3: wrap the cut part into the left and right edges of the window

step 4: use the leftover scraps to overlap with the extension just left on the upper and lower edges of the window

step 5: cut from top to bottom along the edge of the overlapped wall cloth with a ruler and an art knife

step 6: remove the excess wall cloth and wipe the excess glue with a white towel or sponge

长春牛皮癣医院

绍兴男科医院

绍兴男科医院

昆明皮肤病医院

Copyright © 2011 JIN SHI